IP Video Surveillance Forum

Hello C-MOR forum,

I installed C-MOR on HYPERV. All went fine and I could finish all steps of the installation docu. Unfortunately it is not working. The console does not show an IP/Mac address.

Does C-MOR run on HYPERV?

Thomas

Hi,

Yes, C-MOR works on HyperV. This has been succuesfully tested.

Simply add another network adapter to the C-MOR VM and use "Old Network Adapter" or "Legacy....". After you reboot C-MOR select "Network Reset" from the start menu and C-MOR will setup the just added network adapter to configure it through the console.

Michael