IP Camera Configuration in C-MOR
C-MOR is very easy and quick to understand. This how-to describes how to setup an IP camera inside the C-MOR video surveillance web page. It takes a view seconds only and C-MOR records an IP camera. Optimization in motion detection or the length of recordings can be done later. C-MOR supports a wide range of IP cameras which are all available in the configuration menu. Simply select the camera you want to hook up to C-MOR and all is done.
C-MOR video surveillance is configured by web interface only. All settings are made through the web management surface.
Log in to your C-MOR video surveillance system. Simple enter the IP address of the C-MOR in your web browser window. A new C-MOR has the IP 192.168.1.2 as standard. If it is a C-MOR3 you will get following web page with disabled IP cameras:
All the configuration parameters of C-MOR are in the System Administration menu. This includes also the settings for IP cameras.
Scroll down to the section where you can configure IP cameras and select for example the first IP camera, cam1:
Simply enter the IP camera address and access data in the Cam Network Data form:
Also, select the camera type from the Cam Type section and then press Save Configuration. At this point all required parameters for a basic motion and time-lapse recordings are made already:
Once the settings have been saved the IP camera has to be enabled by clicking simply on "Start recording" in the Saved Configuration page.
The status shows now, that recording has been activated:
If all parameters are right, it will show in the next page (the start page) the live view of the camera:
|C-MOR Video Surveillance||Phone: +49 7471 93 01 99 20|